Schneider Electric Communication Drivers - Manual (Page 43)

TSX FPP 20 card
43
Configuration of the Windows NT operating system
At a Glance After the driver installation and configuration phase, the operating system shall
recognize the TSX FPP 20 card and its driver.
How to configure
the operating
system The following procedure describes how to configure the operating system:
Case in which
the driver does
not start One possibility is that the default IRQ3 is busy, in which case another one must be
used:
Follow the steps below to detect an available IRQ:
Note: When configuring the system, it is not necessary to restart the station.
Step Action
1 Install and configure the driver.
2 Shutdown your machine.
3 Insert the PCMCIA card into its slot.
Result:
The system automatically detects the card and loads the driver.
Step Action
1 In the taskbar, select "Start ->Run".
2 enter the command "Winmsd"
3 Select the tab "Resources", choose an available IRQ and confirm with OK.
4 Edit the DSCP114.REG file and modify the value of "InterruptNumber"
5 In the taskbar, select "Start ->Run", enter the command "DFPP20" and
confirm.
6 Restart your machine.