Schneider Electric Communication Drivers - Manual (Page 145)

Functions
145
Modbus Test tab This tab is used to test the basic operation of a Modbus driver:
The table below describes the different zones of the window:
Command buttons
Object Description
Connect Opens an internal communication channel on the selected driver.
Launch Launch request transmission to the station defined in the Remote
address field of the Driver group.
Further
information...
Displays system information about the driver. This button is active in
online mode only.
Concerning Displays X-Way Manager version and copyright details.
Link Parameters Group
Field Description
Protocol Name of protocol used (USB, TCP, Serial Modbus, Modbus Plus).
Remote IP
address
If TCP is being used, then the IP address or machine name is shown
here
Slave No. If Serial Modbus protocol is being used, then the slave no. is shown
here.
Management properties of SCHNEIDER drivers
SCP114 Driver MODBUS SERIAL Driver PCX57 Driver
UNITELWAY Driver PLC USB Driver DRIVERS Manager
FPC10 Driver FPP20 Driver MODBUS Test XWayTest
Requests Link Parameters
OK
Connect Launch Concerning
USB Protocol:
90.0.0.1 Remote IP address:
1 Slave no.:
0 Master Path : DM 0 0 0 0
Request:
Status: Disconnected