Schneider Electric Communication Drivers - Manual (Page 37)

37
4
TSX FPP 20 card
At a Glance
Subject of this
Chapter This chapter describes installation of the driver used to communicate in Fipway\Fipio
mode via the TSX FPP K200 connection kit with a remote device.
Driver installation consists of three steps:
l installation of files on the station,
l configuration of the driver,
l configuration of the operating system to recognize the driver.
What’s in this
Chapter? This chapter contains the following topics:
Topic Page
How to install the driver 38
How to install the driver 40
Configuration of the Windows 98 operating system 41
Configuration of the Windows 2000\XP operating system 42
Configuration of the Windows NT operating system 43