Schneider Electric Communication Drivers - Manual (Page 64)

TSX FPC 10 ISA card
64
Procedure To adjust the parameters, proceed in the following manner:
Example of IRQ
selection The interrupt address provided by the system is 10:
Example of
standard
address
selection The standard address provided by the system is equal to 210 in hexadecimal:
Step Action
1 Set the IRQ interrupt jumper to comply with the address provided by the windows
98 (See How to configure hardware parameters for Windows 98, p. 58) or
2000/XP (See How to configure hardware parameters for Windows 2000\XP,
p. 60) operating systems.
2 Code the standard I/O address provided by the operating system windows 98
(See How to configure hardware parameters for Windows 98, p. 58) or 2000/XP
(See How to configure hardware parameters for Windows 2000\XP, p. 60) with
the micro-switches.
Note: The jumper must not be set in the IRQ position.
3 5 10 11 15 IRQ
1 2 3 4 5 6 7 8
ON
200 100 80 40 20 10