Schneider Electric Communication Drivers - Manual (Page 34)

TSX SCP 114 card
34
Configuration of Win NT operating system
At a Glance After the driver installation and configuration phase, the operating system shall
recognize the TSX SCP 114 card and its driver.
How to configure
the operating
system The following procedure describes how to configure the operating system:
Case in which
the driver does
not start One possibility is that the default IRQ3 is busy, in which case another one must be
used:
Follow the steps below to detect an available IRQ:
Note: So that the driver is loaded when the card is inserted, it is essential that the
station is restarted to update the registry.
Step Action
1 Install and configure the driver.
2 Shutdown your machine.
3 Insert the PCMCIA card into its slot.
Result:
The system automatically detects the card and loads the driver.
Step Action
1 In the taskbar, select "Start ->Run".
2 enter the command "Winmsd"
3 Select the tab "Resources", choose an available IRQ and confirm with OK.
4 Edit the DSCP114.REG file and modify the value of "InterruptNumber"
5 In the taskbar, select "Start ->Run", enter the command "DSCP114" and
confirm.
6 Restart your machine.