Schneider Electric Communication Drivers - Manual (Page 23)

Serial port
23
Advanced
parameters The parameters are presented in the following manner:
This tab is used to configure the line type:
l PC: uses the driver to connect to a series 7 PLC terminal port,
l Uni-Telway: default value, uses the driver to communicate in Uni-Telway,
l Num PLC: uses the driver to connect to NUM PLCs.
l RX/TX Delay: by default set to –1; is used to extend the return time (if the
station is too fast).
l Link Timeout: by default set to –1; is used to set the maximum time for
detecting the right transmission speed.
l Force Virtual Com Port: must be checked if the Unit-Telway driver uses a virtual
communication port except for use with the TSX PCX 3030 cable.
Link Parameters Advanced Uni-Telway
OK Cancel
Parameters of the Station
TimeOut Link
RX/TX Delay
Type of link
Other
PC
Uni-Telway
PCL No.
-1
-1
Force Virtual Com Port