Schneider Electric Communication Drivers User Manual
Page 31
TSX SCP 114 card
31
Line parameters
The parameters are presented in the following manner:
This tab is used to configure the parameters linked to transmission:
l
transmission speed of between 300 and 19,200 bits/s,
l
Time-out,
l
Number of data bits: specifies the size of the data exchanged over the line,
l
parity: is used to set whether a parity bit is added or not, as well as its type,
l
number of Stop bits: is used to enter the number of stop bits used for
communication,
l
RTS/CTS delay: enables the CTS signal to be used in the event of multidrop
communication.
The Default button is used to reset all these parameters to their default value.
Link Parameters
Speed
ms
7 bits
Uni-Telway
OK
Cancel
Station Parameters
9600 bits/s
Delay
10
Default
RTS/CTS Delay
X 100 ms
Default
Data Content
Parity
Stop Bits
8 bits
1 bit
2 bits
Even
Odd
Without
Cancel
1
Apply