Powerware 5075 kVA - Manual (Page 69)

61 Powerware BPIII Harsh Environment UPS 50--75 kVA Installation and Operatio n
164201261 Rev. F 111503
Select Time from the Setup menu to display the Time Setup screen. The Time
Setup screen allows you to set the internal timestamp of the UPS. The timestamp
is used for logging events in the Event History Log. Figure 31 shows the Time
Setup screen.
Statistics Graphics Setup
Setup
Time
Uninterruptible Power System
UPS System Normal
Alarm:
None
Notice: None
Events Meters
Port 1
Set Time & Date
DAY DT
MON 07
MON
APR
YR
98
HR:MN
15:06
SAVE
YES
Port 2
04 MAY 1998 14:25:55
100%
Percent
Battery
Figure 31. Time Setup Screen
The small return arrow ( ) appears in the upper right corner of the Time Setup
screen. This arrow is a reminder that you can press the
pushbutton on the
Monitor Panel to toggle the pushbuttons between the menu box and the
information area. When the scroll bar is in the information area, the return arrow is
in the menu box. When the scroll bar is in the menu box, the return arrow is in the
information area.
When the scroll bar appears in the information area, you can use the pushbuttons
to change the timestamp settings. To change a setting in the timestamp, press the
and pushbuttons to highlight the setting you want to change. To increase the
setting (make it a higher value), press the pushbutton. To decrease the setting
(make it a lower value), press the pushbutton. If you want to save the settings
upon exit from this screen, be sure the SAVE field is set to YES.