Nortel Networks DCT1900 - Manual (Page 160)

Technical Product Manual - DCT1900
Installation Instructions, or BDVNB 101 01/3
4-6 Install-DCT1900/R8/mw
© 2000-2005
4.5 Pre–mounting of a Modular Cabinet in a One Cabinet System
1. Refer to paragrah 4.4.
2. Remove the front cover of the cabinet (see Figure 4–4):
-
Remove the screws that secure the cover (1).
- Lift the front cover approximately 3/8” (2).
- Remove the cover by lifting the lower edge towards you (3).
Fig. 4–4 Removal of the Front Cover and the Drawer
3. Remove the drawer for easy installation:
-
Open the drawer by pulling it toward you (4).
- Release the drawer by pulling the left or right hand side of the drawer down as indicated in
Figure 4–4 (5) and remove the drawer (6). The drawer is hinged by the two screws on its
sides. These do not need to be removed to take the drawer out. Replace the two front
cover screws so that they do not get lost.
4. Remove the screw of the securing bar at the front of the Modular Cabinet and remove the
securing bar. Replace the screw so it does not get lost.
5. Secure the mounting bracket to the wall, so that the bottom side of the Modular Cabinet is
about 5.25 ft. above the ground using the appropriate hardware (typically #8 wood or sheet
metal screws). See Fig. 4-1.
6. Hang the cabinet onto the mounting bracket and mark the location of the two retaining holes
on the bottom of the cabinet.
7. Remove the cabinet and drill the lower mounting holes as needed.
8. Continue with Paragraphs 4.8 or 4.9 as needed.
1
2
3
5
Front Cover
conductive tape
or break-out plate
Drawer
6
1
4