Nortel Networks DCT1900 - Manual (Page 197)

Technical Product Manual - DCT1900
Installation Instructions, Cell Link Unit (CLU-S) –REX-BRD0016 or ROFNB 157 16/2
Install-DCT1900/R8/mw 8-3
© 2000-2005
Fig. 8–2 Power Distribution on the CLU-S
8.3 Installation
1. Insert the CLU-S into the card guides in the specified board position.
2.
Gently push the board into the back connector until it locks. Don’t use any force.
3. Connect the CLU power cable, TSRNB 101 33.
4. Connect the CLU signal cable, NTM/TSRNB 101 29.
+T
CLC 8
P0
P1
SC0
SC1 Base Station 8
CLC 1
SC0
SC1
EPP0, 1
Base Station 1
Power from
MCCB
EPP0, 1
+T
+T
+T
Thermistor
CLU-S