Nortel Networks DCT1900 - Manual (Page 308)

Technical Product Manual - DCT1900
Installation Instructions, Modular Cabinet – Cables
26-4 Install-DCT1900/R8/mw
© 2000-2005
26.5 Power Cable Switch/Backplane – TRENB 101 05
The power cable switch/backplane (see Figure 26–4) is a 2–wire 2.5mm
2
cable with two
connectors on both sides. It is used to supply power from the switch to the backplane in the
Modular Cabinet. On the switch side two piggy–back fastons are attached. Two fastons are
mounted on the side of the fuse holder. This cable does not need to be ordered separately. It is
factory connected between the fuse holder and the backplane.
Fig. 26–4 Power Cable Fuse/Backplane – TRENB 101 05
K3
K4
16 in " .4 in
Cap Faston
Cap Piggy-back
Faston of other cable