Nortel Networks NN43001-106 - Manual (Page 481)

Feature operation 481
Prompt Response Description
CODE MWUD Multiple Wake Up deactivation.
- MWUD xxxx Multiple Wake Up deactivation code Analog (500/2500 type)
telephones.
MWUD is prompted until <CR> is entered.
LD 56 - Set Automatic Wake Up special error tone and configuration tone.
Prompt Response Description
REQ NEW
CHG Add new data.
Change existing data.
TYPE FTC Flexible Tones and Cadences data block.
TABL 0-31 Flexible Tones and Cadences (FTC) Table Number. To
associate a FTC table with trunk route, enter the table number
in response to the TTBL prompt in LD 16.
...
HCCT YES Hardware Controlled Cadences and Tone modification of the
hardware controlled cadence tone definitions allowed.
...
- FFCT Flexible Tone and Cadence.
- - XTON xxx Flexible Tone and Cadence confirmation tone.
China xxx = 211
North America xxx = 004
- - XCAD xxx Cadence code for Firmware Cadence Table (FCAD) as entered
at Cadence Number (WCAD) prompt.
China xxx = 110
North America xxx = 000
- AWUT Automatic Wake Up.
- - XTON xxx Automatic Wake Up special error tone.
China xxx = 214
North America xxx = 007
- - XCAD xxx Cadence code for Firmware Cadence Table (FCAD) as entered
at Cadence Number (WCAD) prompt.
China xxx = 100
North American xxx = 017
Feature operation
The following feature operations occur if the WUD prompt (Wake Up
Delimiter) and STE prompt (Standard Time Entry) are set to YES in LD 15.
If WUD = YES and STE = NO, then the user must dial all four standard time
digits and an octothorpe for a valid entry. If WUD = NO then the STE prompt
will not appear. In this case, the prior operation exists and the user is not
expected to enter the delimiter (#) at the end of time entry. However, all four
Nortel Communication Server 1000
Features and Services - Book 1 of 6 (A to B)
NN43001-106 01.04 Standard
Release 5.0 27 July 2007
Copyright © 2007, Nortel Networks
.