Texas Instruments TMS320C64x DSP - Manual (Page 29)

Video Port Registers
Overview 1-12 SPRU629
For Y/C video display, the FIFO is configured as a single channel split into sep-
arate Y, Cb, and Cr buffers with separate read pointers and write registers
(YDSTA, CBDST, and CRDST). Figure 1–10 shows how Y data is output on
the VDOUT[9–0] half of the bus and Cb/Cr data is multiplexed and output on
the VDOUT[19–10] half of the bus.
Figure 1–10. Y/C Video Display FIFO Configuration
Cr Buffer
(1280 bytes)
Cb Buffer
(1280 bytes)
CRDST
CBDST
64
64
VDOUT[19–10]
8/10
8/10
Y Buffer
(2560 bytes)
YDSTA
64
VDOUT[9–0]
Display FIFO
8/10
1.3 Video Port Registers
The video port configuration register space is divided into several different
sections with registers grouped by function including top-level video port
control, video capture control, video display control, and GPIO.
The registers for controlling the video port are in section 2.7.
The registers for controlling the video capture mode of operation are shown
in section 3.13. An additional space is dedicated for FIFO read pseudo-registers
as shown in section 3.14. This space requires high-speed access and is not
mapped to the register access bus.
The registers for controlling the video display mode of operation are shown in
section 4.12. An additional space is dedicated for FIFO write pseudo-registers
as shown in section 4.14. This space requires high-speed access and is not
mapped to the register access bus.
The registers for controlling the general-purpose input/output (GPIO) are
shown in section 5.1.
Video Port FIFO / Video Port Registers