Printronix SL_T5R Energy Star - Manual (Page 120)

120
Chapter 3 MEDIA CONTROL
Pre-Peel Mode
• Disable (factory default).
• Enable . When Media Handling = Peel-Off and Peel-Off Mode = Standard,
enabling Pre-Peel Mode adds a forward and reverse motion to each label
prior to printing. The added forward pre-peel motion temporarily breaks
the die cut label from the liner, and the reverse motion places the label
back on the liner prior to printing, peeling, or dispensing the label. Pre-
Peel Mode is usually enabled only when using die cut labels with an
aggressive adhesive that makes automatic label removal from the liner
difficult.
Pre-Peel Adjust
When Pre-Peel Mode = Enable, Pre-Peel Adjust represents the selectable
distance that the label advances during Pre-Peel Mode. The Pre-Peel Adjust
distance selected is automatically used when Pre-Peel Mode is enabled.
The range is from 0.00 to 2.00 inches in .01 inch increments.
The factory default is 1.00 inch.
Lbl Missing Flt
Allows the Label Taken Sensor to first detect the presence of a label at the
tear bar.
• Full Label . The printer generates a fault condition if a missing label is
encountered. (Peel Off and Tear Off handling modes only).
• Early Detect . Once the label has moved forward 1.35 inches or the set
label length (whichever is shorter), the sensor checks whether the label
has advanced or not. (Tear Off, Tear Off Strip, and Continuous handling
modes). If no label is detected by the label taken sensor after the first 1.35
inches of motion, the "LABEL WRAP:Open Head To Clear" fault is
declared. When used in Cut handling the setting does nothing. When
used in Peel-Off handling the settings behave the same as "Full Label".
• Disable . The printer does not generate a fault condition if a missing label
is encountered.
The default is Full Label.