Printronix SL_T5R Energy Star - Manual (Page 206)

206
Chapter 3 EPSON FX SETUP
Ignore Ch#1
Specifies character 1 for the character filtering option. Valid decimal values
are from 0 through 255.
The factory default is 0.
Ignore Ch#2
Specifies character 2 for the character filtering option. Valid decimal values
are from 0 through 255.
The factory default is 0.
Ignore Chars
• Disable (factory default). Character filtering is not enabled.
• Char 1 . Character 1 will be filtered. Select the option “Ignore ch#1” to
specify character 1.
• Char 2 . Character 2 will be filtered. Select the option “Ignore ch#2” to
specify character 2.
• Char 1&2 . Characters 1 & 2 will be filtered. Select the options “Ignore
ch#1” and “Ignore ch#2” to specify values for these characters.
Ignore Dots
• Disable (factory default). The VGL expects position values to be specified
in tenth inches and dot rows.
• Enable . Causes the VGL to expect position values to be specified in only
1/10ths of an inch. If the dot position is also given, it is treated as text.
Ignore ^Lxx Cmd.
• Disable (factory default)
• Enable . The Form Length commands ^Lxx and ^Hxx will be ignored, and
the form length will be determined by the “Form Length” menu in the
LP+ menu.
Ignore Mode
This parameter instructs the IGP to ignore the character selected under the
Select Character menu.
• Disable (factory default). The IGP does not ignore any characters.
• Enable. The IGP ignores the character specified in the Select Character
menu.