Printronix SL_T5R Energy Star - Manual (Page 328)

328
Chapter 6 Diagnostics for E0xx, Bad NVM, or ILL NVM Errors
PWR SUPPLY HOT
See Manual
Yes Power supply is hot. 1. Determine that the fan is
operating and that all air
vents are unobstructed.
2. Move the printer to a
cooler area.
3. If the problem persists,
contact your authorized
customer service
representative.
RBN TAKEUP FULL
Remove Used Rbn
Yes The ribbon takeup
spool is full. 1. Empty the takeup spool.
2. If the takeup spool is not
full, try re-threading the
ribbon.
3. Disable Rbn Takeup Full in
the MEDIA CONTROL
menu.
Remove Label Yes • A label was
detected at the
front of the printer
by the Label Taken
Sensor. This is the
normal reminder
message when
Peel-Off or Tear-
Off Media Handling
has been selected.
• A label was
removed, but the
“Remove Label”
message
remained.
• The incorrect
Media Handling
mode was
selected.
1. Remove the label from the
front of the printer to allow
the next label to print.
2. Verify that a front door
assembly is installed on
the printer and that it is
properly closed. Ensure
that no debris is
obstructing the door mirror
or the Label Taken Sensor.
3. In the QUICK SETUP or
MEDIA CONTROL menu,
change Media Handling to
the correct selection.
RESETTING
PLEASE WAIT
Yes Printer finished loading
the program into flash
memory and is
automatically resetting
itself. No action required.
RESTORING
BOOT CODE
Yes Normal download
initialization message. No action required.
Table 18. LCD Message Troubleshooting (continued)
Displayed Message
Can User
Correct?
Explanation Solution