Printronix SL_T5R Energy Star - Manual (Page 212)

212
Chapter 3 EPSON FX SETUP
Position Aft FF
Allows you to select the location of the print position after a Form Feed
command is sent.
• Off (factory default). Sets the printer to print at position 2 of the first print
line on the next form.
• On . Sets the printer to print at print position 1 of the first print line on the
next form.
Power on PGL
You can set the PGL feature so that it is enabled or disabled when the printer
is powered on.
• Enable (factory default). The PGL is enabled when the printer is powered
on. (The PGL feature is initialized in the Normal mode.)
• Disable . The PGL is disabled when the printer is powered on. (The PGL
feature is initialized to the Quiet mode.)
Power-up ^F
• Disable (factory default).
• Enable . Selects free format mode as the power-up default, and selects
the graphics mode ^PY as the power-up default. Free format causes the
VGL to ignore carriage returns, line feeds, and all characters below 20
hex sent from the host.
Power-up ^PY
• Disable (factory default).
• Enable . Selects the graphics mode ^PY as the power-up default.
Power-up ^X
• Disable (factory default).
• Enable . Selects the ignore mode as the power-up default, and selects the
graphics mode ^PY as the power-up default. All characters are ignored
until a ^A command is received.
Preparser Port
Allows you to send preparser commands to the printer through any port.
• Disable (factory default). Not using the Preparser command.
• Enable . The preparser command can be accepted from any port.
Primary Subset
This item allows selection of the desired primary character subset used by the
printer. The factory default is ASCII (USA).