405
Orientation option, 100, 112
OVERALL GRADE FAIL fault message, 324
Overstrike option, 210
Overwrite Files option, 143
P
P/S MISMATCH fault message, 327
PA1 option, 211
PA2 option, 211
PAA option, 137
PAA Select Tool option, 103
Page Mem Adjust option, 145
Page Rotation option, 211
Paper Empty (PE) signal, Centronics parallel
interface, 283
Paper Feed Shift option, 97, 110
Paper Instruction (PI) signal, Centronics
interface, 283
PAPER OUT Load Paper fault message, 325
Paper Out Sensor option, 130
Paper Out Thresh option, 130
PAPER OUT TIMEOUT fault message, 326
Paper path
installing, 43
removing, 51
Parallel interfaces, Centronics, 282
PARALLEL PORT
menu, 229
submenus, 230
Parallel Port, downloading software, 267
PARITY ERROR fault message, 326
Parity option, 234
PDF Size Comp option, 211
Peel Present option, 123
Peel-Off option, 124
Peel-Off, media handling, 28
PGL, 151
PGL Normal option, 211
PGL SETUP menu, 168
Physical dimensions, 339
PI Ignored option, 230
PI Slew Range option, 211
Pin assignments, Centronics parallel interface, 282
PJL Control option, 145
Platen Label Wrap, 306
Platen Roller, cleaning, 70
PLEASE WAIT fault message, 326
PNE, 12
PNE Port Number option, 262
PNE Port option, 262
PNE Port Timeout option, 262
Poll Character option, 238
Poll Response option, 238
POOR SCANNING Check Head&Heat fault
message, 326
POOR SCANNING Inspect head fault
message, 326
POR option, 241
Port Type option (C/T Port), 241
Port Type option (Parallel Port), 230
Port Type option (Serial), 234
Position Aft FF option, 212
Positioning the media sensor, 54
Power consumption, 338
Power Mgmt option, 254
Power on IGP/PGL option, 212
Power On Reset option, 241
POWER SAVER MODE fault message, 326
Power Saver Time option, 141
Power source and grounding, 338
Power switch, 23
Powering on the printer, 27
Power-on, 27
Power-up ^F option, 212
Power-up ^PY option, 212
Power-up ^X option, 212
Power-Up Config. option, 103, 105
Power-up configuration, specifying, 78
Power-up State option, 141
PPI/TGL, 12
PPI/ZGL, 12
Preamble option, 254
Pre-Peel Adjust option, 120
Pre-Peel Mode option, 120
Primary Subset option, 212
Prime Signal option (Parallel Port), 231