Printronix SL_T5R Energy Star - Manual (Page 95)

95
QUICK SETUP
QUICK
SETUP
(from page 84)
Print
Intensity
Print
Speed
Print
Mode 7
-3*
-15 to 15
6 ips*
1 ips to 10 ips 1
Transfer*
Direct
Media
Handling
Tear-Off Strip*
Tear-Off
Peel-Off
Cut
Continuous
Paper Feed
Shift
0.00 inches* 2
-1.00 to X inches
3
Label
Length
4 or 6 inches* 2, 4
00.1 to 99.0 inches
4
Label
Width
4.1, 6.6, or 8.5 inches*
2, 4
00.1 to 8.5 inches 4
Ver Image
Shift
0.00 inches
2
-1.00 to X inches 3
Hor Image
Shift
0.00 inches*
2
-1.00 to 1.00 inches
Orientation
Portrait*
Landscape
Inv. Portrait
Inv. Landscape
Gap/Mark
Sensor 5
Disable
Mark
Gap
Advanced Gap*
Advanced Notch
Auto Calibrate
Run Calibrate
Validator
Funct. 6
Enable*
Disable
Active IGP
Emul
PGL*
ZGL
TGL
IGL
STGL
DGL
IEGL
MGL
VGL
Save Config.
1*
1-8
Notes:
* = Factory Default
1 Maximum value depends on the printer model width (4, 6, or 8 inches) and printhead (203 or 300 dpi).
2 You can change the unit value from inches to millimeters under Units (in MEDIA CONTROL) when Admin User is
enabled.
3 Based on the current value setting for the Label Length (in QUICK SETUP), up to a maximum of 12.80 inches.
4 Maximum value depends on the width of the printer model (see Appendix A, “Specifications”).
5
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown in Table 6 on page 127. If you change
the Gap/Mark Sensor or Paper Out Sensor, you must recalibrate the media.
6 Appears only if a validator is installed.
7
This menu will not appear on Direct Thermal only printers.
8
xxx represents the emulation name selected in the Active IGP Emul menu. The options in this menu vary and are
described on page 140.
Power-Up
Config.
Factory*
1-8
xxx
Diagnostics 8
See footnote 8.