Printronix SL_T5R Energy Star - Manual (Page 370)

370
Appendix G The PTX_SETUP Commands
ENGINE MEDIA_HANDLING Value Sets the type of media handling:
0 - Continuous
1 - Tear-Off Strip
2 - Tear-Off
3 - Peel-Off
4 - Cut
MIRROR Value Value of 0 turns mirroring off,
non-zero turns mirroring on.
MODE X Sets the print mode to Thermal
Transfer.
D Sets the print mode to Direct
Thermal.
WIDTH Value Sets the page width in 1/1000” units.
ODV 1 Enables the ODV unit so that ODV
begins verifying printed barcodes.
RFID OVERSTRIKE_REPORT ON/OFF Enables/disables reporting of RFID
overstrikes to the host. The default
is OFF (disabled).
STATISTICS_REPORT ON/OFF Enables/disables reporting of RFID
statistics to the host. The default is
OFF (disabled).
STATISTICS_CLEAR Clears the RFID statistics.
PRINTJOB START jobID Start of job marker. Results in a
“start of job” message sent back to
host through the PPM port when a
job starts printing.
END jobID End of job marker. Results in a “end
of job” message sent back to host
through the PPM port when the job
finishes printing.
Table 33. Thermal PTX_SETUP Commands
Command Sub-Command Parameter Description