Alpha Technologies AMPS80 HP - Manual (Page 53)

51 Doc. #: 026-069-B0 Rev F
precise.)
a. Select Inverters > View Live Status> Inverter Report.
b. In the Inverter Report screen, locate the module for AC phase 1: click each row until the LEDs of the
inverter in the first phase 1 shelf flash for a few seconds.
c. Using the pull down box in the Module Number column, set the module number to 1 to correspond
to AC phase 1.
d. Locate the module for AC phase 2: click each row until the LEDs of the inverter in the first phase 2
shelf flash for a few seconds.
e. Use the pull down box to set the module number to 2 to correspond to AC phase 2 (for split phase,
2-pole and 3 phase systems).
f. Repeat for a third module (select 3 to correspond to AC phase 3) if the system is 3 phase.
21. Now that the inverter modules in each shelf have a number, place one module in each of the AC input
and output groups as follows:
Select a row to send a
Locate command; the in-
verter module LEDs will
flash for a few seconds.
Module number
pull down box
Figure 32 —
Inverters > View Live Status