Alpha Technologies AMPS80 HP - Manual (Page 76)

Doc. #: 026-069-B0 Rev F 74
6.4.5 Mapping Alarms to Relays
1. Connect a computer to the controller. Refer to the controller software manual. The 48 V DC power must
be switched on before the controller can operate. Provide either DC power on the main DC1 or DC4
connections or switch on at least one rectifier.
2. Navigate to Alarms > Configure Alarms.
3. Select Digital Inputs.
Select Digital Alarms
Select desired relay
If this popup appears
select another relay
4. Select the desired relay. In this example K7 and K8 are available.