Alpha Technologies AMPS80 HP - Manual (Page 70)

Doc. #: 026-069-B0 Rev F 68
6.3.13 General Settings
This submenu of Inverters enables the supervisor to set the parameters shown below:
Figure 49 —
General settings window
Value 0 or 100 only.
For inverters, chang-
es apply on a page
by page basis; select
Submit
.
Select
Cancel
to
discard all changes
made (including
invalid settings).
The Free Running Frequency min/max setting is determined by the General Settings value. If AC input is pres-
ent, AC output will synchronize; however an irregular AC voltage could damage the inverters.
6.3.14 Manage Config File
The inverter settings have their own configuration and are not part of the full site configuration file. Refer to
Chapter 10 for a list of the configuration file parameters and steps to save the file and upload it to another
system.
Figure 50 —
Manage Config File window