Hach-Lange SI794 C User Manual - Manual (Page 33)

2-EL
(2-EL/ 4-EL)
33
Note: Characters represented in gray are blinking and can be edited.
Code Display Action Choices
o1 .
Select configuration
(Press conf.)
For parameter set 1:
Enter passcode “1200”
Select position using 4 arrow
key and edit number using 5
key. When the display reads
“1200”, press enter to confirm.)
For parameter set 2:
Enter passcode “1288”
Select position using 4 arrow
key and edit number using 5
key. When the display reads
“1288”, press enter to confirm.)
The transmitter is in the HOLD
mode (HOLD icon is active).
Select sensor*
(Display/selection only in
parameter set 1)
2-electrode sensor /
4-electrode sensor
Select using 4 key.
Press enter to proceed
After correct input a
welcome text (CONF)
is displayed for approx.
3 sec
After correct input a
welcome text (CONF)
is displayed for approx.
3 sec
*) These parameters are only edited in parameter set 1.
They are valid for both parameter sets.