ZOLL R Series Monitor Defibrillator Rev K Operators Guide - Manual (Page 131)

9650-0904-01 Rev. K ZOLL R Series Operator’s Guide 12–1
Chapter 12
File Transfer
This chapter describes procedures for transferring files from the R Series defibrillator to an
external system, such as a personal computer or handheld device. It also explains how to
remove, install and erase a Compact Flash card.
Note: The USB and Wi-Fi capabilities that are included in this chapter are only available if
you have the R Series Plus model. The file transfer option is only available when you
are in Manual mode.
While you are in Transfer Data mode, if you press any of the buttons on the right side of the
front panel (SHOCK, ANALYZE, CHARGE, ENERGY SELECT), the following message
is displayed: SELECT DEFIB MODE. To enable the defibrillator in Manual mode, press the
Exit Transfer softkey, or quickly turn the Mode Selector to OFF and then ON.
Transferring Files to an External Device
You can transfer the following files from the R Series defibrillator to an external device:
• Device check, activity log, and full disclosure waveforms
• Defibrillator test information
The unit includes the following data transfer features:
• 802.11 Wi-Fi (R Series Plus Only)
• USB device connector (R Series Plus Only)
• Compact flash card slot
Note: When the unit is transferring data via Wi-Fi, it is in a non-clinical mode. No treatment
or monitoring of the patient is available in this mode.