Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 157)

6-42
M-4659
When obtaining the IP address from DHCP
• DHCP
Set [DHCP] to [ON].
• DNS accession
To automatically obtain the DNS server address, select [ON]. Otherwise, select [OFF].
If you select [OFF], you must set the IP address of the DNS server.
• Host-Name Register
To automatically register the host name, select [ON].
• Host Name
Set the RD-MV1000/RD-MV2000’s host name using up to 64 alphanumeric
characters.
• Domain Name
Set the network domain name that the MV belongs to using up to 64 characters.
• Server Primary, Server Secondary (not necessary when DNS accession
is enabled)
Register up to two IP addresses for the primary and secondary DNS servers.
• Domain Primary, Domain Secondary
Set up to two domain suffixes: primary and secondary.
Keep Alive
To disconnect when there is no response to the test packets that are periodically sent,
select [ON]. Otherwise, select [OFF].
Time out
To use the application timeout function, select [ON]. Otherwise, select [OFF]. If you
select [ON], a [Timeout time] is displayed.
• Timeout time (min.)
Set the timeout value between 1 and 120 (minutes).
Checking the communication status
The Ethernet communication status can be confirmed with the LED lamp that is provided
on the Ethernet connector on the RD-MV1000/RD-MV2000 rear panel or the [Ethernet
link] that is shown at the upper right of the basic setting screen.
6.6 Entering Basic Settings