Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 162)

6-47
M-4659
Configuring the MV1000/MV2000
1
2
3
4
5
6
7
8
Index
E-mail
Basic Setting
Set the SMTP server and mail address.
• SMTP server name
Enter the host name or IP address of the SMTP server.
• Port No.
Unless specified otherwise, set the number to the default value. The default value is 25.
• Security
Settings Description
OFF Disables POP before SMTP.
POPbeforeSMTP Enables POP before SMTP.
• Address 1, Address 2
Enter the e-mail address. Multiple e-mail addresses can be entered in the box of one
recipient. When entering multiple addresses, delimit each address with a space. Up
to 150 characters can be entered.
• Sender
Enter the sender e-mail address. You can enter up to 64 characters.
POP3 Settings
If you need to use POP before SMTP, specify the POP3 server.
• POP3 Server name
Enter the host name or IP address of the POP3 server.
• Port number
Unless specified otherwise, set the number to the default value. The default value is
110.
• Login name
Enter the POP3 server login name.
• Password
Enter the POP3 server login password. You can enter up to 32 characters.
• Send delay [second]
Enter the wait time from POP3 server authentication until transmission. Set a value in
the range of 0 to 10 (seconds).
6.6 Entering Basic Settings