Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 164)

6-49
M-4659
Configuring the MV1000/MV2000
1
2
3
4
5
6
7
8
Index
System
Specify the settings for sending e-mail when the MV recovers from a power failure, at
memory end, and when an error occurs.
• Recipient1 and Recipient2
Set the e-mail recipients. For Recipient1 and Recipient2, select [ON] to send e-mail
or [OFF] to not send e-mail.
• Include source URL, Subject, and Header
These items are the same as the e-mail that is sent when an alarm occurs. The
default subject is System_warning.
Report
Specify the settings for sending e-mail when reports are created.
• Recipient1 and Recipient2
Set the recipients. For Recipient1 and Recipient2, select On to send e-mail or OFF to
not send e-mail.
• Include source URL, Subject, and Header
These items are the same as the e-mail that is sent when an alarm occurs. The
default subject is Report_data.
6.6 Entering Basic Settings