Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 82)

4-10
M-4659
Displaying Multiple Y-axis
When multi-axis zone is selected, the Y-axis scales corresponding to the [Y-Axis] boxes
in the [General Display Settings] that are checked will be displayed.
• Adding a Y-axis • Deleting a Y-axis
Drag and drop
Drag and drop
Changing the Grid Display
Select the grid type by clicking Grid density on the toolbar, or Y-axis on the menu bar.
Switch the grid density.
Switch the grid density
Waveform Display Limit (clip)
When the waveform display limit is enabled by clicking the clip icon or by selecting
[Y-Axis] - [Clip], the Y-axis display range of the waveform are limited to the minimum
and maximum values that were specified under [General Display Settings] - [Scale].
Measured values that are less than the minimum value are set to the minimum value and
values that are greater than the maximum value are set to the maximum value.
• Example in which Display Limit is Enabled
• Example in which Display Limit is Disabled
4.2 Displaying the Waveform