Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 208)

7-34
M-4659
7.6 Program Control Related Setup Operations
This section describes optional program control related operations.
Turn ON/OFF Program Control
Program control can be turned ON and OFF under Internal Loop in the Setup tab.
Click the Setup tab then select Internal Loop from the list that appears on the left of the
screen. Or, you can select the items by choosing Control Settings > Setup Basic Setting
> Internal Loop.
Select the loop number Click this tab
Program control ON/OFF
(Every two loops Style2 or before. Since Style3 or later at each loop.)
Note
You must first turn ON program control to carry out the program control related settings below.