HP 9100c Digital Sender series - Manual (Page 12)

10 Chapter 1 - Getting started EN
To install on Windows 9x, NT 4.0, or NT 5.0
1 Turn your computer on and quit any open programs.
2 Do one of the following:
• If you get a message from the administrator saying there is
new software available for this product, follow the instructions
in the message for installing it.
• If the software is being installed from the network, log in to the
network, click Start and then Run. Type the path the
administrator gave you and click OK.
• If the software is being installed from the compact disc, the
setup program begins as soon as you insert the compact disc.
When prompted, make sure to choose to install the end-user
software.
3 When the installation program begins, follow the instructions on
the screen. During the installation, you need to specify the
following:
• Which programs to install. By default, all programs are
installed.
• Where to store the programs. You can accept the default
location or choose another location on your computer.
• The path to the default inbox. The default inbox is the place
where data sent to your computer is stored. You can accept
the default location or choose another location on your
computer or the network.
All the programs you selected will be installed. If an error occurs
during installation, see “Installation troubleshooting” on page 11.
Note The target program receives and displays documents sent to your
computer. To learn more about choosing a target program, see
“Configuring the target program” on page 84.
After installation
After installing the software, you or the administrator needs to
establish your registered user profile to allow you to use all the
capabilities of the digital sender. See “Your user profile” on page 12.