HP 9100c Digital Sender series - Manual (Page 80)

78 Chapter 4 - Using the HP Digital Sender Link EN
Running the HP Digital Sender Link
There are two parts to the HP Digital Sender Link: the Control Panel
applet and the program itself. Use the applet to configure settings for
the program. The program itself must be running when you are
sending to the computer.
To start the Control Panel applet
Open the settings dialog box in one of the ways listed below.

From Windows Control Panel, double-click the HP Digital Sender
Link icon.

Right-click in the Windows taskbar and choose Settings.

Double-click .
To start the program
Note The program starts automatically when you turn the computer on, but
you can also start it manually.
1 Click Start, point to Programs, then HP 9100C, and click HP
Digital Sender Link.
2 The program’s receive capabilities must also be enabled when
you want to send to the computer. See “Setting receive
capabilities” on page 83.