HP 9100c Digital Sender series - Manual (Page 27)

EN Quick-start tutorial 25
Sending to a computer
Use the procedures below to send a document to the target program.
The first procedure helps you start the HP Digital Sender Link, which
must be running, and the second procedure helps you send the
document from the digital sender.
Note Only registered users can send to their computers.
To start the HP Digital Sender Link
At the computer to which you will be sending, make sure the HP
Digital Sender Link is running and the receive capabilities are
enabled.

If you see the icon like this: , then the program is running and
the receive capabilities are enabled.

If you see the icon like this: , then the program is running but
the receive capabilities are disabled. Right-click the icon and
choose Enable receive.

If you do not see the icon, the program might or might not be
running. To check or start the program, click Start, point to
Programs, then HP 9100C, and then click HP Digital Sender
Link.
To send to the target program
1 At the digital sender, load the document as described on page 22.
2 Log in (if necessary) and press PC .
3 If your user name is not in the NAME field, type it in.
4 Press to start sending.
5 The document goes to your computer and appears as a file in the
targetprogram.