HP 9100c Digital Sender series - Manual (Page 86)

84 Chapter 4 - Using the HP Digital Sender Link EN
Configuring the target program
The target program is the program where documents sent to your
computer are ultimately received and viewed. You can determine
which program is the target program and whether or not that program
starts automatically when data is received.
Choosing the target program
You can choose any program as the target program, but the program
must accept data in .pdf or multipage .tif format.
To choose the target program
1 In the Control Panel applet, click the Desktop tab.
2 In the Path to target application field, type the path to the
program you want to use as the target program. Include the name
of the program itself as the last item in the path.
- Or -
Click ... to browse and find the path to the program.
3 In the Target application initial path field, type the drive and first
level folder where the program is located. For example,
c:\target program .
- Or -
Click ... to browse and find the initial path to the program.
4 Click Advanced.
5 Make sure the Start With Document File Name check box is
selected. (This enters
%F in the Target Application Parameters
field.) Using this parameter, a newly scanned document will be
displayed automatically when the target program opens.
6 Click OK to save the settings.
7 If you chose a default target program that accepts the multipage
.tif file format instead of .pdf, you must change the file format
setting. See “Changing an existing user profile” on page 53.