Changing an iscsi target's name and host mode, Change host group dialog box (option selected) – HP StorageWorks XP Remote Web Console Software User Manual
Page 103
4.
If necessary, click Option, and select host mode options. For more information about host mode
options, see
.
Figure 48 Change Host Group dialog box (Option selected)
.
NOTE:
After you click Option, the pane expands to display a list of host mode options. The No.
column indicates option numbers. Select the check box for the option you want to specify.
5.
Click OK. Changes are indicated in blue in the table.
6.
Click Apply. A confirmation message appears.
7.
Click OK. Changes to the host group name and host mode are applied to the array.
Changing an iSCSI target's name and host mode
NOTE:
You cannot perform this operation on iSCSI targets for initiator ports.
CAUTION:
Before changing an iSCSI target's host mode, HP recommends that you first back up data on the port
the iSCSI target belongs to. The operation for setting the host mode should not be destructive, but
data integrity cannot be guaranteed without a backup.
1.
Start XP LUN Configuration and Security Manager Software. The XP LUN Configuration and
Security Manager Software pane appears (
).
XP LUN Configuration and Security Manager User Guide
103