Associating host, Groups or iscsi targets to logical volumes, Associating host groups – HP StorageWorks XP Remote Web Console Software User Manual
Page 98: Or iscsi targets to logical volumes
3.
If the host has never been connected via a cable to any port in the array, take the following steps:
a.
In the tree, right-click the iSCSI target, and select Add New iSCSI name. The Add New iSCSI
name pane appears.
Figure 42 Add New iSCSI name pane (registering a host that has never been connected to
the array)
.
b.
In the iSCSI name list, select the host bus adapter. If the list does not include the host bus
adapter, enter the iSCSI name in the iSCSI name box.
c.
If necessary, enter a nickname for the host bus adapter.
d.
Click OK. The specified iSCSI name and nickname appear below the selected iSCSI target.
4.
Click Apply. A confirmation message appears.
5.
Click OK. Settings are applied to the array, and the specified host is registered in the iSCSI
target.
Associating host groups or iSCSI targets to logical volumes
Use XP LUN Configuration and Security Manager Software to define LU paths by associating host
groups or iSCSI targets to logical volumes. For example, if you associate a host group or iSCSI target
consisting of three hosts with logical volumes, LU paths are defined between the three hosts and the
logical volumes.
1.
Start XP LUN Configuration and Security Manager Software. The XP LUN Configuration and
Security Manager Software pane (
or
) appears.
2.
In the tree, select a host group or iSCSI target.
NOTE:
If you are configuring a NAS environment, you must select the User host group.
3.
In the CU list above the LDEV table, select a CU number. The LDEV table shows LDEVs in the
specified CU image.
XP LUN Configuration and Security Manager Software operations
98