HP StorageWorks XP Remote Web Console Software - Manual (Page 140)

3. Right-click any point in the Authentication information (Host) list, and select Add New User
Information (Host). The Add New User Information (Host) pane appears.
Figure 71 Add New User Information (Host) pane
.
NOTE:
You should register user information for all hosts to be connected to an iSCSI target that
performs authentication of hosts. To allow a specific host to connect to such an iSCSI target
without authentication, configure the iSCSI target and the host as follows:
• On the host:
It does not matter whether or not you configure the host for authentication by ports with
CHAP.
However, if the host uses Microsoft iSCSI Initiator, do not configure the host for authen-
tication by ports with CHAP.
Specify the following user information for the host you want to allow to connect:
• Target Name: Host bus adapter's iSCSI name. Select one from the list or enter the name dir-
ectly. In the list, all iSCSI names of host bus adapters connected to the selected port by the
cable appear. For more information about the characters and length you can specify as an
iSCSI name, see
iSCSI port and iSNS server settings .
• User Name: Host's user name of the host up to 128 characters.
You can use alphanumeric characters, spaces, and the following symbols in a user name:
. - + @ _ = : / [ ] , ~
User names are case-sensitive. For example, host1 and Host1 represent different users.
• Secret: Secret (that is, a password used in CHAP authentication) between 12 to 32 characters.
You can use the same characters and symbols as a user name in a secret.
• Re-enter Secret: Specify the secret again for confirmation.
• Protocol: Protocol used in user authentication. This protocol is fixed to CHAP.
4. Click OK. The host's specified user information appears in blue in the Authentication Information
(Host) list.
5. Click Apply. A confirmation message appears.
6. Click OK. Settings are applied to the array.
XP LUN Configuration and Security Manager Software operations 140