HP StorageWorks XP Remote Web Console Software - Manual (Page 25)

Figure 6 Disabling XP Secure Manager
.
Host group 0 is the only host group reserved for each port by default. If you use the XP LUN
Configuration and Security Manager Software pane to view a list of host groups in a port, host group
0 usually appears at the top of the list and is indicated by 00 (see
Figure 2 ).
NOTE:
By default, the name of host group 0 consists of the port name, a hyphen, and 00. For example, host
group 0 for port 1A is named 1A-G00 by default. You can change the name of host group 0.
By default, XP Secure Manager is disabled on each port. When you configure the system, you must
enable XP Secure Manager on each port to which hosts are connected.
For more information, see Using LUN security .
Configuring LUs for use by RAID Manager XP
System administrators can enter RAID Manager XP commands from open-system hosts to perform
Continuous Access XP and Business Copy XP operations on logical devices. For example, administrators
can enter RAID Manager XP commands to create or split pairs. To allow administrators to use RAID
Manager XP commands, you must ensure that at least one logical device is used as a command
device. A command device receives RAID Manager XP commands entered from open-system hosts.
When the administrator enters a RAID Manager XP command from an open-system host, the RAID
Manager XP command is transferred via the command device to the target logical device.
To protect a logical device from RAID Manager XP commands, you must apply command device
security to the logical device. If command device security is applied to a logical device, the device
is not affected by RAID Manager XP commands even when commands are transferred via a command
device to that device.
For more information, see Configuring arrays for using RAID Manager XP commands .
XP LUN Configuration and Security Manager User Guide 25