HP StorageWorks XP Remote Web Console Software User Manual
Page 204
NOTE:
If a VDEV number starts with V (for example, V1-1-(1)), the VDEV belongs to a parity group
that consists of one or more virtual volumes (V-VOLs).
• No.: CVS volume's setting number.
• Emulation: CVS volume's emulation type.
• Capacity: CVS volume's capacity displayed in the unit selected from the Capacity Unit list on
the Install CV pane (1).
• CU:LDEV: CU and LDEV numbers for the CVS volume to be created. The default is blank.
NOTE:
If an LDEV number ends with # (for example, 00:01#), the LDEV is an external LU. For more
information about external LUs, see the
HP StorageWorks External Storage XP user guide.
•
Select LDEV No. area: Used to set LDEV numbers for the CVS volumes you are creating.
• Select CU No.: Select a CU number from the drop-down list. The default is CU 00. LDEV number
settings for the selected CU number appear in the Select LDEV No. table.
• Interval: When selecting more than one volume, use this list to set the interval between the
LDEV numbers to be assigned to the newly created volumes. The default value is 0. When you
select 0, consecutive LDEV numbers are assigned.
NOTE:
The value you specify as the interval between LDEV numbers counts only available LDEV
numbers and skips those that are not selectable.
• Select LDEV No. table: Displays LDEV numbers for the CU number selected from the Select CU
No. list. Gray indicates LDEV numbers that are not selectable, white indicates unused LDEV
numbers, and blue indicates available LDEV numbers. You can select an LDEV number from
the white LDEV numbers in the table. When you set the LDEV number, that LDEV number becomes
available and changes to blue.
NOTE:
LDEV numbers that are not selectable might already be in use or assigned to another emulation
group (grouped by 32 LDEV numbers) (see
).
Custom Volume Size operations
204