HP StorageWorks XP Remote Web Console Software User Manual
Page 97
2.
If the host was previously connected via a cable to another port in the array, take the following
steps:
a.
In the iSCSI name table, select the port to which the host is connected from the Port list.
b.
In the iSCSI name list, select the host bus adapter. From the tree, select an iSCSI target, and
click Add iSCSI name.
Figure 41 Add New iSCSI name pane (registering a host that was previously connected to
the array)
.
• In this list, only iSCSI names of hosts that issued login commands to ports appear. Re-
gardless of the sessions (Discovery or Normal) or results (Accept or Reject), up to 64
iSCSI names of hosts that recently issued login commands to each port appear. However,
if a host issues more than one instance of the login command to the same port, the host's
iSCSI name appears only once in the list.
To register iSCSI names using this list and register multiple hosts collectively to one port,
you must register the iSCSI names to the port before the iSCSI names are deleted from
this list. If the iSCSI names are deleted and you want to redisplay the iSCSI names in this
list, you must reissue the login command from the hosts. In this case, you should operate
the hosts that need to log in, and should not add unnecessary iSCSI names to this list.
• If you are using Windows, you can drag the host bus adapter from the iSCSI name table
to the iSCSI target in the tree. To drag two or more host bus adapters, see the HP Stor-
ageWorks XP Command View Advanced Edition Software user guide for XP Disk Arrays
or the HP StorageWorks XP Remote Web Console user guide for XP12000/XP10000
Disk Arrays and SVS 200 for instructions.
c.
To assign a nickname to the host bus adapter, enter the nickname in the Nickname box,
and click OK.
NOTE:
If you select two or more host bus adapters, Add New iSCSI name panes (
appear one after another to let you assign nicknames to the selected HBAs. If you do
not need to assign nicknames to HBAs, you can select
The remaining iSCSI names do not need names, and click OK. If you select this option,
the Add New iSCSI name pane (
) no longer appears to prompt you to assign
nicknames.
XP LUN Configuration and Security Manager User Guide
97