HP StorageWorks XP Remote Web Console Software - Manual (Page 92)

6. If necessary, click Option, and select host mode options. For more information about host mode
options, see
Table 16 .
Figure 38 Add New iSCSI Target pane (Option selected)
.
NOTE:
After you click Option, the pane expands to display a list of host mode options. The No.
column indicates option numbers. Select the check box for the option you want to specify.
7. Click OK. If a message appears, click OK. The iSCSI target name and host mode appear in blue.
8. Click Apply. A confirmation message appears.
9. Click OK. Settings are applied to the array.
Registering hosts in host groups
NOTE:
If you are configuring a NAS environment, you do not need to follow the procedures described in
this section. For instructions, see
Associating host groups or iSCSI targets to logical volumes .
To set LU paths, you must register hosts in host groups. For example, if HP-UX and Windows hosts
are connected to a port, you must register the HP-UX and Windows hosts separately in two different
host groups.
If you are configuring a Fibre Channel environment, follow the instructions in Registering hosts in host
groups (when configuring Fibre Channel environments) . If you are configuring an iSCSI environment,
follow the instructions in Registering hosts in iSCSI targets (when configuring iSCSI environments) .
Registering hosts in host groups (when configuring Fibre Channel environments)
When registering a host, you must specify the host bus adapter's WWN. If you are unsure of the host
bus adapter's WWN, see
Finding an open-system host's World Wide Name (WWN) .
When registering a host, you can assign a nickname to the host bus adapter. If you assign a nickname,
you can easily identify each host bus adapter in the XP LUN Configuration and Security Manager
XP LUN Configuration and Security Manager Software operations 92