Clear authentication information pane – HP StorageWorks XP Remote Web Console Software User Manual
Page 137
4.
Right-click any point in the FC Switch Information list, and select Clear User information. The
Clear Authentication Information pane appears.
Figure 70 Clear Authentication Information pane
.
5.
Click OK.
6.
Click Apply. A confirmation message appears.
7.
Click OK. Settings are applied to the array.
Specifying a Fibre Channel switch's authentication mode
1.
Start XP LUN Configuration and Security Manager Software, and display the Authentication pane
(
).
2.
In the Port tree, double-click the Subsystem folder. If the array contains Fibre Channel adapters,
the Fibre folder appears below the Subsystem folder.
3.
In the Port tree, double-click the Fibre folder. Information about the Fibre Channel switch appears
in the FC Switch Information list.
4.
Right-click any point in the FC Switch Information list, and select Authentication
unidirectional->bi-directional.
5.
Click Apply. A confirmation message appears.
6.
Click OK. Settings are applied to the array.
To return the Fibre Channel setting, perform the same operation, except select Authentication
bi-directional->unidirectional in step 4.
Specifying whether a Fibre Channel switch can perform authentication
To enable Fibre Channel switches to authenticate hosts, you must enable the Fibre Channel switch's
user authentication settings. By default, Fibre Channel switch authentication is disabled.
To enable a Fibre Channel switch to authenticate hosts:
1.
Start XP LUN Configuration and Security Manager Software, and display the Authentication pane
(
).
XP LUN Configuration and Security Manager User Guide
137