Initializing iscsi target 0 (zero), Changing a host bus adapter's wwn and nickname, 106 changing a host bus adapter's wwn and nickname – HP StorageWorks XP Remote Web Console Software User Manual
Page 106
NOTE:
You cannot perform this operation on host groups for NAS ports.
1.
Start XP LUN Configuration and Security Manager Software. The XP LUN Configuration and
Security Manager Software pane (
) appears.
2.
In the tree, right-click host group 0, which is preceded by 00, and select Clear Host Group. A
confirmation message appears.
3.
Click Yes.
Host group 0's host mode and host group name change in the tree. WWNs are also removed
from host group 0.
LU paths are removed from the table on the right of the tree. LUNs corresponding to the removed
LU paths appear in blue.
4.
Click Apply. A confirmation message appears.
5.
Click OK. Settings are applied to the array.
Initializing iSCSI target 0 (zero)
If you follow the procedure below, iSCSI target 0 (zero) is set to its initial state. This procedure removes
all LU paths related to iSCSI target 0. This procedure also changes iSCSI target 0's host mode to
Standard and initializes the iSCSI target name. After this procedure, the iSCSI target's name changes
to its default name.
1.
Start XP LUN Configuration and Security Manager Software. The XP LUN Configuration and
Security Manager Software pane (
) appears.
2.
In the tree, right-click iSCSI target 0, which is preceded by 00, and select Clear Host Group. A
confirmation message appears.
3.
Click YES.
iSCSI target 0's host mode and host group name are changed in the tree. iSCSI names are also
removed from iSCSI target 0.
LU paths are removed from the table on the right of the tree. LUNs corresponding to removed LU
paths appear in blue.
4.
Click Apply. A confirmation message appears.
5.
Click OK. Changes are applied to the array.
Changing a host bus adapter's WWN and nickname
In Fibre Channel environments, you can identify host bus adapters by WWNs or nicknames.
1.
Start XP LUN Configuration and Security Manager Software. The XP LUN Configuration and
Security Manager Software pane (
) appears.
2.
In the tree, double-click the Fibre folder. A list of Fibre Channel ports appears.
3.
In the tree, double-click the Fibre Channel port to which the host bus adapter is connected.
XP LUN Configuration and Security Manager Software operations
106