HP LaserJet 9040.9050 Multifunction Printer series - Manual (Page 151)

ENWW Understanding MFP messages 147
CLOSE FRONT OR
LEFT DOOR
To continue turn
off then on The MFP was turned on with one of these doors open. Close the door, turn the
MFP off, and then turn the MFP on.
CLOSE RIGHT DOOR Close the vertical transfer door.
CLOSE RIGHT DOOR
To continue turn
off then on The MFP was turned on with the right door open.
CLOSE STAPLE
DOOR Close the stapler access door on the output paper handling device.
Creating...
CLEANING PAGE The MFP is generating the cleaning page.
DATA RECEIVED The MFP has received data but is waiting for a form feed or has been paused.
DIFFERENT PAPER
SIZES IN JOB Different media sizes are being used for a single job in the multifunction
finisher.
Verify that all pages in the job are configured for the same size paper.
Deleting... The MFP is deleting a stored job.
Digital Send
server is not
responding
Contact
administrator The MFP cannot communicate with the server. Verify the network connection.
DUPLEXER ERROR
REMOVE DUPLEXER
Install duplexer
with power off The duplexer has been removed. Reinstall the duplexer.
EIO X DISK NOT
FUNCTIONAL The EIO hard disk is not working correctly.
Follow the instructions in the on screen dialog box.
E-mail Gateway
did not accept
the job because
the attachment
was too large The scanned documents have exceeded the size limit of the e-mail server.
Resend the job using a lower resolution, smaller file size setting, or fewer
pages. Contact your network administrator to enable sending the scanned
documents using multiple e-mails.
E-mail Gateway
did not respond An e-mail gateway has exceeded the time out value. Verify the e-mail address.
Message Explanation or recommended action