HP LaserJet 9040.9050 Multifunction Printer series - Manual (Page 83)

ENWW Copying multiple sized originals 79
Background removal
If you copy a document that is printed on colored paper, or if you use two-sided copying, you can
enhance the copy quality by removing any background that might cause your copy to streak or
blur. Touch the
Enhance button to gain access to the embedded Background Removal screen.
Adjust the amount of background removal by touching the arrows on the Background Removal
control. The slider moves to the lighter or darker area of the Background Removal control bar.
Sharpness
The Sharpness control specifies the sharpness setting that the flatbed scanner uses when the
MFP scans your original. Sharpness enhances the edges of the original so that faint or fine text
and graphics are reproduced more sharply. Adjust the amount of sharpness by touching the
arrows on the Sharpness control bar.
Contrast
The Contrast control allows you to determine the contrast and brightness of your copy. Touch the
arrows on the Contrast control, and move the slider to the lighter or darker area of the Contrast
control bar.
Copying multiple sized originals
If the original document contains mixed-size originals, for example, a letter-size document with
several legal-size charts, see
Using Job Mode for more information.
Creating a stored copy job
Turning on the job storage setting indicates that you want the copy job to be stored on the hard
disk, and that you will print the job later. You must provide the following information to create a
stored job:
1 Touch Copy .
2 Select your basic copy settings (see Copying by using user-defined settings ).
3 Touch the Advanced tab.
4 At the Job Storage box, select On .
A popup dialog box is displayed, asking for the User Name , and Job Name. If Authentication
Required is selected, a Personal Identification Number (PIN), if required. To enter the PIN,
touch the small box next to Authentication Required . The keyboard is displayed when you
select User Name and Job Name . The PIN is a four-digit number that can be typed on the
numeric keypad.
5 Type the User Name .
6 Type the Job Name .
7 Type the PIN, if required.
8 Touch OK .
9 Press S TART
.
See Printing a stored job for information on printing a stored job.