HP LaserJet 9040.9050 Multifunction Printer series - Manual (Page 209)

ENWW Configure device menu 205
SHOW ADDRESS=OFF AUTO
OFF Sets whether or not the MFP IP address will be shown with
the Ready message. If this value is “on” the address of the
EIO card in slot 1 is shown.
TRAY BEHAVIOR USE REQUESTED
TRAY
MANUAL FEED
PROMPT
PS DEFER
MEDIA Specifies the behavior of the tray by indicating which tray the
MFP should print from.
USE REQUESTED TRAY sets the tray that the MFP should print
from for specified jobs. The values for this menu item are
EXCLUSIVELY (default) or FIRST .
MANUAL FEED PROMPT determines whether or not the MFP
prompts the user when a job does not match a requested
configured tray. The values for this menu item are
ALWAYS
(default) or UNLESS LOADED .
PS DEFER MEDIA sets whether the paper-handling model is
based on PostScript rules or HP rules. The values for this
menu item are
ENABLED (default) or DISABLED .
SLEEP DELAY=90
MINUTES 1 MINUTE
15 MINUTES
30 MINUTES
60 MINUTES
90 MINUTES
2 HOURS
4 HOURS Sets how long the MFP remains idle before it enters Sleep
mode:
● Minimizes the amount of power consumed by the MFP
when it is idle.
● Reduces wear on the MFP electronic components (turns
off the display backlight).
● When you send a print job, press a control panel key,
open a paper tray, or open the top cover, the MFP
automatically exits Sleep mode.
Note
Sleep turns off the backlight on the display, but the display is
still readable.
WAKE TIME
SUBMENU SETTING WAKE
TIME Sets the time that the MFP automatically comes out of Sleep
mode. This feature can be set for a different time for each
day of the week.
PERSONALITY=AUTO AUTO
PCL
PS
PDF
XHTML
MIME Select the default product language (personality). Possible
values are determined by which valid languages are installed
in the MFP.
Normally you should not change the product language (the
default is
AUTO ). If you change it to a specific product
language, the MFP does not automatically switch from one
language to another unless specific software commands are
sent to the MFP.
CLEARABLE
WARNINGS=JOB ON
JOB Set the amount of time that a clearable warning appears on
the printer control panel.
ON : Warning messages appear on the control panel until they
are cleared.
JOB : Warning messages appear on the control panel until the
end of the job from which they were generated.
Item Values Explanation