HP LaserJet 9040.9050 Multifunction Printer series User Manual
Page 38
34 Chapter 1 The basics
ENWW
6
Close the tray.
7
Look at the control panel within a few seconds of closing the tray. (Open and close the tray if
the time has already elapsed.) The control panel displays the tray size and type
configuration. Do one of the following:
• If the size and type settings are correct, touch
EXIT
to accept the settings.
• If the size and type settings are not correct, touch
OK
. The
TRAY N SIZE=*<SIZE>
menu is
displayed.
8
To change the size setting, touch the correct paper size. The message
SETTING SAVED
is
displayed for a moment, and then the tray type menu is displayed.
Note
Depending on the size that you selected, the MFP might prompt you to move the Custom/Standard
switch in the tray to another position. The MFP might also prompt you to move the paper guides.
Follow the instructions on the control panel, close the tray, and then repeat this procedure starting
with step 7.
9
To change the type setting, touch the correct paper type. The message
SETTING SAVED
is
displayed for a moment, and then the size and type settings are displayed.
10 If the size and type settings are correct, touch
EXIT
to accept the settings. The tray is ready
to use.