HP LaserJet 9040.9050 Multifunction Printer series - Manual (Page 210)

206 Appendix B Control panel menus ENWW
AUTO CONTINUE=ON ON
OFF Determine how the MFP reacts to errors.
ON : If an error prevents printing, the message is displayed,
and the MFP goes offline for 10 seconds before returning
online.
OFF : If an error prevents printing, the message remains on
the display, and the MFP does not print until Continue is
touched.
Note
To stop printing when out of staples (when a stapler
accessory is installed), set
AUTO CONTINUE=OFF in the control
panel System setup menu.
CARTRIDGE LOW=
CONTINUE CONTINUE
STOP Determine how the MFP functions when toner is low. The
CARTRIDGE LOW message first appears when approximately
two weeks of typical printing remain in the cartridge. This
allows you sufficient time to order a new print cartridge.
CONTINUE : The MFP continues to print while the CARTRIDGE
LOW message is displayed.
STOP : The MFP goes offline and wait for further action.
For more information, see Managing the print cartridge .
CARTRIDGE
OUT=CONTINUE STOP
CONTINUE Determine how the MFP behaves when toner is out.
CONTINUE : The MFP displays REPLACE CARTRIDGE until the
cartridge is replaced. The MFP continues to print.
STOP : The MFP goes offline and waits until the cartridge is
replaced.
JAM RECOVERY=
AUTO AUTO
ON
OFF Determine how the MFP functions when a jam occurs.
AUTO : The MFP automatically selects the best mode for MFP
jam recovery (usually ON ). This is the default setting.
ON : The MFP automatically reprints pages after a jam is
cleared.
OFF : The MFP does not reprint pages following a jam.
Printing performance might be increased with this setting.
LANGUAGE=ENGLISH List of
available
languages Sets the language of the control panel.
Item Values Explanation