HP LaserJet 9040.9050 Multifunction Printer series User Manual
Page 219
Advertising
ENWW
Installing memory 215
3
Loosen the two captive thumb screws on the back of the MFP.
4
Grasp the screws and pull the formatter board out of the MFP. Place it on a flat,
non-conductive surface.
5
Remove the DIMM from the antistatic package. Hold the DIMM with fingers against the side
edges and thumbs against the back edge. Align the notches on the DIMM with the DIMM
slot. (Check that the locks on each side of the DIMM slot are open, or outward.)
Note
See
for the maximum amount of memory for each DIMM slot.
Advertising