HID FARGO HDP8500 User Guide - Manual (Page 110)

© 2012 HID Global Corporation. All rights reserved.
110
HDP8500 Industrial Card Printer/Encoder User Guide L001617 rev 1.1
Selecting the Full Card
Step Procedure
1 Select the Full Card option to print the resin black (K) Panel for all black
found within all areas of the image, as shown below.
The Card image becomes fully black.
The resin prints anywhere for black.
The Add and Delete buttons become inactive and are grayed out.
The Defined Area object size and location scroll controls become inactive
and are grayed out.
The inches and mm dials become inactive and are grayed out.
Selecting the Defined Area and Undefined Area
Step Procedure
1 Select the Defined Area(s) option to print the resin black (K) Panel for all
black found only in an area or areas defined, as shown below.
The card image becomes white with the grid and one area (available for
the User to start with).
The defined areas print black with resin.
It is through this card grid that up to five areas can be defined.
When the card grid is first activated, then a small black square will
appear at its default size of .2 x .2 (5mm x 5mm) and at its default
location in the lower left-hand corner (0,0). (Note: This square
represents the first defined area.)
2 Select the Undefined Area(s) option to print the resin black (K) Panel for all
black found only in the space outside the areas defined, as shown below.
The card image becomes black with the grid and one area (available for
the User to start with).
The defined area does not print black with resin.